Evans Stripcoat

stripcoat type i

Evans Stripcoat Type I

All Type I versions of Evans Stripcoat are based on Ethylcellulose

Learn More
stripcoat type ii

Evans Stripcoat Type II

All of our Type II coatings are based on Cellulose Acetate Butyrate

Learn More
stripcoat type iv

Evans Stripcoat Type IV

Evans Stripcoat Type IV coatings are based on thermo-plastic rubbaer.

Learn More

Stripcoat Melting Tanks

Temperature control is the most important factor in the use of Evans Stripcoat. We recommend heated thermostatically controlled melting equipment.

Special sizes available upon request.

Learn More

Easy Application

Application is easy. Just immerse the item into the molten plastic for a few seconds and withdraw. Solidification occurs within one minute. The coating does not adhere to the item’s surface, but “envelopes” it in a protective jacket. Aluminum foil or a small piece of tape can be used to seal any crevices or holes that the plastic should not fill as it covers the item.

Learn More